Assembly complete
Congratulations, you have now assembled your Strobe-Enhaced Microscope Station.
Electronic Components
- 1 Raspberry Pi Power Supply
- 1 Strobe Power Supply
- 1 Voltage regulator - This regulator has modifications documented here
Step 1: The completed station
Your completed station should now look like these pictures.
Step 2: Power up the station
To power up your station you will need two 5V/3A power supplies: one with a USB-C connector for the Raspberry Pi and one with a male 5.5x2.1mm jack connector for the strobe illumination.
Use a voltage regulator to supply 3V to the strobe. Higher voltage can damage it.
Step 3: Software set-up
Setting up the software is included in the next section of instructions. It is detailed in "Software Installation" page. Using the software is described in the "Use your Station" page.